10 Reasons Why Your Irrigation Pump Not Turning On
Irrigation pumps are a necessary part of keeping your garden or farm irrigated, but what do you do when they stop working? Your irrigation pump not turning on for a number of reasons, the most common being a lack of power or water. Other reasons could be a burnt-out motor, clogged filters or damaged wiring. In this article, we’ll take you through 10 reasons your irrigation pump might not be turning on, and what you can do to fix the problem.
Here are 10 reasons your irrigation pump might not be turning on, and what you can do to fix the problem:
1) Lack of Power
This could be due to an issue with the wiring or fuse, which are usually located in your home’s breaker box. If you suspect a lack of power is the issue, check the breaker box and reset any tripped breakers. You may also need to replace any blown fuses.
2) Lack of Water
This could be due to a misaligned or broken sprinkler, a clogged hose, or damaged or broken pipes. Before you start troubleshooting sprinkler pump, be sure to check that all of your valves are open and there is water flowing to the pump.
3) Burnt-Out Motor
This is often caused by water or other debris getting into the motor and causing it to overheat. To determine whether your motor is burnt out, try turning on your pump and checking for any unusual smells or sounds.
4) Clogged Filters
This can occur if your irrigation system hasn’t been cleaned for a while, or if there is debris in the water. To clean your filters, remove them from the pump and rinse them with clean water. If they’re excessively dirty, you may need to replace them.
5) Damaged Wiring
This can be caused by rodents or other animals chewing on the wiring, or by water or other debris getting into the wiring. If you suspect damaged wiring is the issue, be sure to shut off power to the pump before attempting to repair or replace any damaged wires.
6) Wrong Size Pump
If your irrigation system is too small or too large for your property, it may not be able to provide the water pressure you need. This can also occur if your pump is too old or damaged, since older pumps may not be able to pump a large volume of water.
7) Blocked Drain Lines
This can happen if your pump isn’t draining properly, which can cause a build-up of water and debris. To clear blockages, be sure to shut off power to the pump and then use a pipe cleaner or other drain-cleaning tool to remove any debris.
8) Low Water Pressure
If your pump doesn’t have the right amount of water pressure, it may not be able to provide enough water for your irrigation system. This can occur if you have a leak in your system, or if your water pressure is too low.
9) Leaking Pump
This can happen if there is a hole or crack in your pump, or if the seals are damaged. If you suspect your pump is leaking, be sure to shut off power to the pump and then check for any leaks.
10) Incorrectly Installed Pump
This can happen if your pump is not installed correctly, which can cause a number of issues including low water pressure, leaks, and poor performance. If you’re not sure how to install your pump, be sure to consult with a professional.
1046 Axlewood Cir, Brandon, FL 33511
Leave A Comment